CCNA 4 Chapter 8

1. Excessive broadcasts are generally a symptom of a problem at which layer?

data link

2. Refer to the exhibit. Users at Branch B are reporting trouble accessing a corporate website running on a server that is located at HQ. HQ and Branch A users can access the website. R3 is able to ping 10.10.10.1 successfully but not 10.10.10.2. The users at Branch B can access servers at Branch A. Which two statements are true aboutthe troubleshooting efforts? (Choose two.)

Frame Relay at R3 and R2 should be tested to narrow the scope of the problem.
An ACL entry error could cause the failure at Layer 4 in either R3 or R2.

3. What is one example of a physical layer problem?

incorrect clock rate

CCNA 4 Chapter 7

1. Refer to the exhibit. IPv6 address 2006:1::1/64 eui-64 has been configured on the router FastEthernet0/0 interface. Which statement accurately describes the EUI-64 identifier configuration?

The configuration will derive the interface portion of the IPv6 address from the MAC address of the interface.

2. Refer to the exhibit. Which address or addresses represent the inside global address?

209.165.20.25

3. Your organization is issued the IPv6 prefix of 2001:0000:130F::/48 by your service provider. With this prefix, how many bits are available for your organization to create subnetworks?

16

CCNA 4 Chapter 6

1. Which two Layer 1 requirements are outlined in the Data-over-Cable Service Interface Specification (DOCSIS)? (Choose two.)

channel widths
modulation techniques

2. Which is an example of symmetric-key encryption?

pre-shared key

3. Which two statements are valid solutions for a cable ISP to reduce congestion for users? (Choose two.)

allocate an additional channel
subdivide the network to reduce users on each segment

CCNA 4 Chapter 5

1. Refer to the exhibit. What will be the effect of the configuration that is shown?
Users attempting to access hosts in the 192.168.30.0/24 network will be required to telnet to R3.

2. Which three parameters can ACLs use to filter traffic? (Choose three.)

protocol suite
source address
destination address

3. Refer to the exhibit. How does this access list process a packet with the source address 10.1.1.1 and a destination of 192.168.10.13?

It is dropped because it does not match any of the items in the ACL.

CCNA 4 Chapter 4

1. What is the best defense for protecting a network from phishing exploits?

Schedule training for all users.

2. What are three characteristics of a good security policy? (Choose three.)

It defines acceptable and unacceptable use of network resources.
It communicates consensus and defines roles.
It defines how to handle security incidents.

3. The Cisco IOS image naming convention allows identification of different versions and capabilities of the IOS. What information can be gained from the filename c2600-d-mz.121-4? (Choose two.)

The software is version 12.1, 4th revision.
The IOS is for the Cisco 2600 series hardware platform.

CCNA 4 Chapter 3

1. Which best describes the benefit of using Frame Relay as opposed to a leased line or ISDN service?

Customers only pay for the local loop and the bandwidth they purchase from the network provider.

2. Which statement about Frame Relay subinterfaces is correct?

Point-to-point subinterfaces act like leased lines and eliminate split-horizon routing issues.

CCNA 4 Chapter 2

1. Refer to the exhibit. What can be concluded about the function of the Serial 0/0/0 interface on the router after the commands are entered?

The serial link will be closed if the number of received packets at the destination node falls below 90 percent of the packets that are sent.

2. Refer to the exhibit. While troubleshooting a serial interface, a technician enters the command show interface serial 0/0/0 . If the interface is in DCE mode, what two problems are likely to cause the indicated problem? (Choose two.)

The remote CSU or DSU has failed.
A timing problem has occurred on the cable.

CCNA 4 Chapter 1

1. Which statement about WAN protocols is correct?

Most WAN protocols use HDLC or a variant of HDLC as a framing mechanism.

2. Which statement is true of the functionality of the layers in the hierarchical network model?

The distribution layer aggregates WAN connections at the edge of the campus.

3. Which WAN technology uses a fixed payload of 48 bytes and is transported across both switched and permanent virtual circuits?

ATM

Final CCNA 3 ( F )

1. Refer to the exhibit. The network administrator needs to setup Switch1 for remote access from HostA. The show ip interface brief is issued on Router1 and the show interfaces trunk command is issued on the
Switch1 to verify the current status. The administrator applies the additional configuration shown in the exhibit to Switch1. However, the telnet from HostA fails. What additional commands need to be applied to the switch?

Switch(config)# interface vlan 1
Switch(config-if)# ip address 10.1.1.250 255.255.255.0
Switch(config-if)# no shutdown
Switch(config-if)# ip default-gateway 10.1.10.254

Switch(config)# interface vlan 1
Switch(config-if)# ip address 10.1.50.250 255.255.255.0
Switch(config-if)# no shutdown
Switch(config-if)# ip default-gateway 10.1.50.254

Switch(config)# interface vlan 10
Switch(config-if)# ip address 10.1.10.250 255.255.255.0
Switch(config-if)# no shutdown
Switch(config-if)# ip default-gateway 10.1.10.254

Switch(config)# interface vlan 10 ******TRUE
Switch(config-if)# ip address 10.1.1.250 255.255.255.0
Switch(config-if)# no shutdown
Switch(config-if)# ip default-gateway 10.1.10.254

Switch(config)# interface vlan 50
Switch(config-if)# ip address 10.1.10.250 255.255.255.0
Switch(config-if)# no shutdown
Switch(config-if)# ip default-gateway 10.1.10.254

Final CCNA 3 ( E )

01. Refer to the exhibit. A network administrator needs to add IP phones to the network. To which devices should the IP phones connect?
xxAS1 and AS2
DS1 and DS2
DS1, DS2, and CS1
AS1, AS2, DS1, and DS2

02. Refer to the exhibit. What would happen if the network administrator moved the network cable of Host A from interface Fa0/1 to Fa0/3 on switch SW1?
Host A remains a member of VLAN 10, because the router is routing traffic between VLANs.
xxHost A is no longer a member of VLAN 10, because port Fa0/3 has been manually assigned to VLAN 30.
Host A remains a member of VLAN 10, because the switch provides dynamic VLAN assignment for the port.
Host A maintains connectivity to all members of VLAN 10, because it is connected to the same physical network.
Host A is no longer a member of VLAN 10, but because port Fa0/3 was unused, it is now a member of VLAN 1.

Final CCNA 3 ( D )

01. Refer to the exhibit. R1 is configured for traditional inter-VLAN routing. R1 can ping computer 3 but cannot ping computer 1. What is a possible cause for this failure?
xxS1 port Fa0/11 is in the wrong VLAN.
R1 does not have an active routing protocol.
The IP address of computer 1 is in the wrong logical network.
Router interface Fa0/0 has the wrong trunk encapsulation type configured.

02. Refer to the exhibit. What will be the result of the commands that are shown in the exhibit?
Only clients on VLAN 2 will be able to use DHCP for addressing.
xxDHCP server responses will only be permitted on interface Fa0/2.
Only 100 clients are permitted to request DHCP addresses on VLAN 2.
Client requests for DHCP addresses will be filtered out if the requests are not received on interface Fa0/2.

Final CCNA 3 ( C )

1. Refer to the graphic. Which of the following commands would be used on the router to provide communication between the two hosts connected to the switch?
interface vlan 2
ip address 192.168.2.1 255.255.255.0
no shutdown
interface vlan 3
ip address 192.168.3.1 255.255.255.0
no shutdown
*** interface fastethernet 0/0
no shutdown
interface fastethernet 0/0.2
encapsulation dot1q 2
ip address 192.168.2.1 255.255.255.0
interface fastethernet 0/0.3
encapsulation dot1q 3
ip address 192.168.3.1 255.255.255.0
interface vlan 2
switchport mode trunk dot1q
interface vlan 3
switchport mode trunk dot11
interface fastethernet 0/0
mode trunk dot1q 2 3
ip address 192.168.2.1 255.255.255.0

2. Refer to the graphic. If the switches are new and have been cabled as shown, which switch will become the root bridge?

*** SC
CE
JB
JP
JN
cannot be determined from the information given

Final CCNA 3 ( B )

1.Refer to the exhibit. A network administrator needs to add IP phones to the network. To which devices should the IP phones connect?
xxAS1 and AS2
DS1 and DS2
DS1, DS2, and CS1
AS1, AS2, DS1, and DS2

2.A wireless client is attempting to establish a connection with a wireless access point. What process does the client use to discover the access points which are available to it?
xxprobing
beaconing
association
authentication

Final CCNA 3 ( A )

1. Which value determines if a switch becomes the central point of reference in the spanning tree topology?
xxlowest bridge ID
highest revision number
lowest numeric IP address
highest numeric MAC address

2. Refer to the exhibit. What is the purpose of the configuration commands that are shown?
to activate port Fa0/10
xxto make the port a member of VLAN 30
to activate port security on port Fa0/10
to add VLAN 30 to the trunk that is connected to port Fa0/10